This product is custom made and takes 2 weeks to ship.
Poly StepGuard is a water-based sealer that dries clear. Poly StepGuard is a 1-part solution with no VOCs that requires no mixing. It ‘s available with antiskid or without antiskid. It bonds effectively with various flooring surfaces, and won’t etch or damage your floor’s natural appearance.
It acts a waterproof sealer. It protects surfaces and grout lines from stains and discoloration caused by liquids, cleaning products and other contaminates. It has built-in UV protection that shields surfaces from fading, as well as mildewcides to prevent the growth of mold and mildew.
Poly StepGuard With Antiskid prevents slip and fall accidents in areas that are less likely to become extremely wet or slippery. It offers a relatively smooth texture, and provides slip resistance with the use of very small aggregate particles and nanotechnology materials; similar in texture to 400-grit sandpaper.
Poly StepGuard is designed for indoor surfaces that need anti slip protection, but must maintain a close appearance to the original surface. It is a favorable solution for polished stone surfaces such as marble and granite found in homes and lobbies; as well as wood- or vinyl-laminate flooring in homes and office environments. This eco-friendly product contains extremely low VOC’s, and has no fumes or odors. It can be applied easily with a paint brush, paint roller or low pressure airless spray.
- Green: Non-Toxic, Minimal VOC’s, Fumes, Odors
- Multi-Surface Solution
- Ease of Application
- Single Component Product (No Mixing Req’d)
- Highly Water Resistant
- Does Not Mold or Mildew
- Protects Grout Lines
- Quick Drying Times
- Enhanced for UV Protection (Does not yellow, crack or peel)
- Does Not Harm Underlying Floor Surface
- Does Not Attract Dirt
- Stain Resistant
- Easy To Clean
Poly StepGuard may be used in homes and commercial applications, to increase safety and to prevent slip and fall injuries. Its durability outlasts competitors, and reduces the need for expensive floor care and maintenance. This eco-friendly product contains extremely low VOC’s, and has no fumes or odors. It can be applied easily with a paint brush, paint roller or low pressure airless spray.
Poly StepGuard may be applied by brush, roller (short nap) or low pressure airless spray. A gallon of SolidStepGuard can provide protection over approximately 350 to 400 square feet depending on the nature of the surface. Stir or shake the Poly StepGuard container vigorously to mix well prior to use. The targeted surface should be free of dirt, debris and oil or grease, prior to application. The coating goes on easily and dries to a clear glossy finish.
One coat is usually sufficient. However if a second is coat is desired, allow the first coat to dry thoroughly for an hour or more depending on ambient temperature. Allow 24 hours or more for full cure before subjecting the surface to heavy traffic. Do not apply at temperatures below 5°F or above 90°F. Avoid heavy buildup, puddling and overlapping. See Product Specifications sheet. High Humidity will impact curing time. Do not apply in very humid environments.
Appropriately mask off areas that need to be kept free of Poly StepGuard. Wipe off overruns, spills and splatters immediately with water. Thoroughly clean hands and tools after use with soap and warm water. Observe all personal precautions as you would with any other paint or coating product.